Block 01
GPS tracker
Tracking, trips and idle times over a 5-pin harness. Plus and ground are enough, installed in under 30 minutes.
Our own hardware · Real-time data
Telematics & tracking
GPS tracker, blackbox, contactless CAN reader and remote immobilizer. Pre-configured by HYGHSOFT, live in your platform. From cold start to border crossing, nothing gets past you.
Scroll
How it works
Power in.
Power in.
Data out.
The device draws power from the vehicle, determines its position via GNSS and sends everything to the platform over cellular. In the app you see location, trips and alerts.
Step 01
Vehicle
Powered via plus and ground, optionally with ignition detection for precise trips and idle times.
Step 02
Device
GNSS position plus motion sensor. The blackbox additionally reads the CAN bus: speed, rpm, engine load, fuel level.
Step 03
Platform
Transmitted over cellular within seconds. Live map, logbook, alerts and driving report right in HyghFleet.
The system
Four building blocks.
Four building blocks.
One circuit.
From the lean tracker to the blackbox with immobilizer: the components mesh and grow with your requirements.
Block 01
Block 02
Blackbox
The hub: bundles GPS and CAN data and switches up to two immobilizers.
Block 03
CAN reader
Reads speed, rpm, engine load and fuel level contactless through the insulation. No wire gets cut, which matters for warranty and leasing.
Block 04
Immobilizer
A standard automotive relay in the starter or fuel circuit, controlled from the app. Only blocks the next start, never a moving vehicle.
14:08:11Cold engine revvedEngine pushed hard at low temperature5,860 rpm · 46 °C
14:16:34High engine loadLoad in the very high range for a notable period94 %
14:27:52Elevated speedAbove the usual range for regular road use214 km/h
14:31:06Hard kickdownAbrupt load change with strong power demand96 % pedal
14:39:48Very high speedVehicle moved into a clearly elevated speed range247 km/h
14:41:02Hard brakingForceful deceleration from high speed-8.7 m/s²
The driving report
Evidence, not
Evidence, not
assertions.
"I drove perfectly normally." The driving report shows what really happened: every event in chronological order, with reading and timestamp. No score, no artificial metrics, just verifiable facts as a PDF.
Driving style
Donuts in the parking lot? It's in the log.
Burnouts, drifts and full-load orgies leave patterns on the CAN bus. HyghFleet detects them before bravado becomes engine damage.
Court-ready
In court, only what's documented counts.
Timestamps, readings and signatures make the driving report a solid basis: for deposit withholding, insurance cases and in court.
See for yourself
Read a real driving report.
A complete rental weekend as an anonymized PDF: exactly the document your customer gets to see.
Get the PDF
Immobilizer & protection
One click.
One click.
Engine stays off.
If a vehicle leaves its allowed zone or a rental goes unpaid, you block the next engine start straight from the app. Try it on the right. A moving vehicle is never switched off.
- Border alert and geofencing against embezzlement
- Block engages only at the next start attempt
- Motion sensor detects towing and tampering
Immobilizer · live demoBMW M4 · WH-XY 404
Ready to startRelay closed · engine can start
No command sent yet. Click the button.
Damage detection
When it crashes,
When it crashes,
you know first.
Hard decelerations and impact patterns report instantly via push, before the customer invents a story.
14:41:02Impact detectedForceful deceleration from high speed-8.7 m/s²
14:41:04Push sent to youLocation and driving report attacheddelivered
Installation
Plug in.
Plug in.
Pair. Done.
Every device arrives pre-configured. If you can hold a wrench, you can do the install yourself: documented step by step, with pinouts, good and bad mounting spots and all LED codes. Alternatively any car workshop completes it in under an hour.
Retrofitting pays off
Your fleet.
Your fleet.
Under your control.
Tell us how many vehicles you want to equip. You get a clear quote for hardware, installation and platform.